The Lee Precision Classic Turret Press has a solid steel linkage, a hardwood gripped lever and an iron base. Long stroke allows rifle cases up to 3.75 inches long to be loaded using the automatic index. Deactivate the Auto-Index and cases over 4 inches can be loaded. The rigid cast iron frame supports the ram with over 12 square inches of area. Dispenses primers in the attached clear PVC tube.

The Lee Precision Classic Turret Press has all the features of the award-winning Turret Press with quality touches that make this the finest, most convenient press to own. The Classic Turret features the solid steel linkage of the Lee Classic Cast. Your first stroke of the hardwood gripped lever will convince you this is one, solid silky smooth press! The sturdy iron base shows its Classic Cast roots.

Instant change turrets are the same as the famous Lee Turret Press. The Classic Turret Press uses the new Lee Lever Primer System (LPS). The Lee Safety Prime tool makes priming on the press a delight.

Features:

• Solid steel linkage
• Hardwood gripped lever
• Sturdy Iron Base
• Up to 3.75" cartridges can be loaded with the Automatic Index
• Rigid Cast Iron Frame

Note:

• If you are using the Auto-Disk Powder Measure on this press, the Auto Disk Riser will need to be purchased to provide adequate clearance for the Lee Safety Prime.
• For Instructions and more information, click on the "Man" Icon.

IT IS YOUR RESPONSIBILITY TO ENSURE THE SAFETY OF YOUR LOADS

FACTORS THAT WILL INCREASE PRESSURES. SOME WILL BE DANGEROUS:

• DO NOT USE more powder than recommended
• DO NOT USE a heavier bullet than recommended
• DO NOT SEAT the bullet deeper than normal
• DO NOT USE magnum primers unless using a slow burning ball powder
• Greatly oversize bullets, excessively hard bullets or cases that are too long will cause higher pressures
• High temperatures or cartridges that were stored in a hot car or trunk will produce higher pressures